Skip to content
CalamityCorners Locksmith Co.Open 24/7 (226) 271-6061
Technician inspecting splintered wood around a door-frame strike plate. — Break-In Damage Lock Repair, Masonville

Lockouts · Masonville

Break-In Damage Lock Repair

There is a hole where the cylinder used to be. Somebody twisted it out of the deadbolt with a wrench, and now the empty bore looks straight through to the kitchen, with the bolt still stuck in the frame.

In plain words

Break-ins seldom come through the door with the strongest lock. Sliding patio doors are lifted off their track or pried at the latch, the garage man-door carries a light knob lock, a basement walkout is out of sight, and a storefront's narrow-stile deadbolt sits behind a bendable aluminum edge. Each needs its own repair: anti-lift blocks and a foot bolt for the slider, a proper deadbolt and reinforced strike for the side door, a latch guard and repaired stile for the shop. Break-in damage lock repair covers whichever opening was attacked and looks over the others while the tools are already out.

Sound familiar?Masonville

The call
There is a hole where the cylinder used to be. Somebody twisted it out of the deadbolt with a wrench, and now the empty bore looks straight through to the kitchen, with the bolt still stuck in the frame.

NextHow the visit goes

Break-In Damage Lock Repair · Masonville

How the visit goes

Illustrative locksmith scene — Masonville
  1. Scene 1

    Does the door still hang true

    An impact hard enough to break a strike usually moves the door as well. The locksmith checks that the door sits square in its opening, closes on its weatherstrip without force, and that the bolt lines up with its pocket rather than dragging on the strike lip. Hinge screws are tested for grip, since a kick can pull them from the jamb even on the side that was not attacked, and the hinge leaves are checked for bending. Manufacturers treat strike position, pocket depth and door alignment as working parts of the lock, and a repair that ignores them produces a door that locks badly the day after it was fixed.

  2. Scene 2

    Fitting the new deadbolt and cylinder

    The replacement hardware is chosen for the door and for the attack it suffered. A deadbolt with a full one-inch throw, a hardened insert against sawing and a low-profile face that resists a wrench grip is the usual choice, graded to a recognised durability standard rather than the lightest unit on the shelf. It is matched to the existing bore and backset so no new holes weaken the slab, or the preparation is enlarged cleanly where the old hardware was small. The bolt is tested with the door open, then closed, and the strike adjusted until it throws without dragging. Trim and finish are matched to your other doors where you want that.

  3. Scene 3

    For tenants and landlords: who holds what

    In a rental the repair closes with keys changing hands properly. Provincial tenancy rules place repairs on the landlord and expect a landlord who changes a lock to give the tenant a key, while a tenant changes locks only with the landlord's agreement. So the locksmith notes who authorized the work, how many keys were cut and to whom they were handed, and leaves a copy for both sides. In a condo or apartment building, the superintendent or property manager receives the same note so master key or fob records stay accurate. Everyone ends the day knowing which key opens the repaired door.

In the van

  • Two-part wood epoxy and shims
  • Wrap-around door edge reinforcer
  • Replacement cylinder or core
  • Grade 1 deadbolt with one-inch throw
  • Rekeying pins and key blanks

What shapes the quoteCalamity Corners Locksmith Co.

Lock failure or frame failure
Replacing a lock is hardware and fitting time. Rebuilding a strike side with a boxed strike, epoxy and long screws into the stud is carpentry as well, and is quoted as its own line.
Number of cylinders rekeyed
Every lock a taken key fits is rekeyed individually, so a house with four exterior doors, a mailbox and two padlocks is more work than one front door. Bringing them all onto a single key is part of the count.
Strike and hinge reinforcement
A security strike box, hinge reinforcement plates and three-inch screws on both sides of the door are listed as their own items, so you can see what strengthens the frame beyond replacing what broke.

FeesSame any hour

Have it ready

Before you call · 0 / 3

(226) 271-6061

Let's clear a few things up

My car was stolen with the garage remote and a house key inside. What now?

Treat it as two exposures. The house key is handled by rekeying every lock it fits. The remote is handled at the garage door opener: its memory is erased so every old remote stops working, and new remotes are programmed. If the car had your address on its paperwork, do both before anything else. A locksmith can rekey the doors and, on many openers, clear the remotes during the same visit or show you the learn button on the motor unit.

Why did the frame break instead of the lock?

Because that is where the weak point was. A standard strike plate is held by two short screws in a soft wood jamb, and the deadbolt only reaches into a shallow pocket behind it. A kick delivers the full weight of a body to those screws, and the wood around them splits along the grain. The bolt itself is rarely the failure. That is why the repair concentrates on the strike side: a boxed strike, a full-depth pocket and long screws into the stud.

Someone reached through the sidelight to turn the thumb-turn. Should I fit a deadbolt keyed on both sides?

It is tempting, but a thumb-turn lets everyone in the household leave by that door without hunting for a key, special device or special knowledge, so a keyed inside cylinder is the wrong fix. Better answers are a tested security-film system or laminated glass in the sidelight to slow an arm from passing, moving the deadbolt beyond arm's reach of the glass where the door allows, and a glass-break sensor if you have an alarm.

Masonvilleinformation

MiddlesexOntario

Town
Masonville, Middlesex
In business
27 years
Hours
Open 24/7
Nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

2021 census: what it means at the door

Every square is one home in a hundred.

  • 52 in 100 homes · older homes
  • About 52% of homes in London were built in 1980 or earlier, according to the 2021 Census.Older doors are usually thicker and made of solid wood, which is good news. They take a deadbolt well, hold longer strike screws, and reward reinforcement. The locksmith measures the thickness and backset so new hardware fits without fresh holes.
  • Single-detached houses make up about 49% of homes in London (2021 Census).Where houses and attached homes share an area, lockouts are as varied as the doors. A porch, a hallway or a shared vestibule each calls for a slightly different approach, and a locksmith used to all three arrives ready for whichever it is.

Source: Statistics Canada, Census Profile

Open Masonville in Google Maps

On-site assessment

Request a visit.

There is a hole where the cylinder used to be.

(226) 271-6061, open 24/7.